I believe that everyone has a certain understanding of the wiper, as the name implies, is to alleviate the impact of rain on the driving line of sight. Those some friends will ask, in the end, how to use the wiper, let's give you a wiper switch diagram.

A:調節旋鈕

A: Adjusting knob

B:前雨刮點動操作（MIST），向上推動控制撥桿到MIST 位置，隨之就會自動回位并且雨刮器刮動一次。

B: The front wiper inching operation (MIST), push up the control paddle to the position of mist, then it will automatically return to its original position and the wiper will operate once.

C:前雨刮關閉（OFF）

C: Front wiper off

D:自動雨刮（AUTO），轉動調節旋鈕可以改變雨量傳感器雨刮器控制的靈敏度，從而調節雨刮器的刮刷頻率。

D: Automatic wiper (auto), turning the adjustment knob can change the sensitivity of rain sensor wiper control, so as to adjust the wiper frequency.

E:低速刮刷（LOW）

E: Low speed wiper (low)
 

F:高速刮刷（HI）

F: High speed wiper (HI)

G:前風窗玻璃洗滌，向駕駛員方向輕拉控制撥桿，擋風玻璃洗滌器和雨刮器就會同時工作。當洗滌器停止工作后，雨刮還會繼續工作一小段時間。

G: To wash the windshield, gently pull the control lever towards the driver, and the windshield washer and wiper will work at the same time. When the washer stops working, the wiper will continue to work for a short time.

那么有些車型的玻璃水開關是通過實體按鈕控制的，通常都是位于方向盤左側/右側控制桿上的外側，只要按壓下去就會噴出玻璃水，同時雨刮器也會同時工作的。但如果發現玻璃水沒有噴出，只是雨刮器工作的話，千萬不要繼續按壓按鈕了，這時候就得看看玻璃水報警燈有沒有亮起，有的話應及時補充玻璃水。

Then, the glass water switch of some models is controlled by a solid button, which is usually located on the outside of the left / right control lever of the steering wheel. As long as it is pressed down, the glass water will be ejected, and the wiper will also work at the same time. However, if it is found that the glass water does not spray out, and only the wiper is working, do not press the button any more. At this time, it is necessary to check whether the water glass alarm light is on. If there is any, the glass water should be replenished in time.